Question

Two steel wide flange beams with the same beam size and same span one is fy=36...

Two steel wide flange beams with the same beam size and same span

one is fy=36 ksi and the other is 50 ksi steel

if the loads are also the same, will one of the beams deflect more than the other.

Engineering   Civil-Engineering   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Problem 6 Design a 10-ft span steel wide-flange beam which that is required to support a...
Problem 6 Design a 10-ft span steel wide-flange beam which that is required to support a uniform service live load of 20 k/ft and a uniform service dead load of 17 k/ft. Assume the beam is 50-ksi. Does moment or shear govern?
Subject: Steel and Wood Design A W24×55 steel beam of Fy=50 ksi is subjected to a...
Subject: Steel and Wood Design A W24×55 steel beam of Fy=50 ksi is subjected to a uniform service dead load of 3 k/ft and a concentrated service live load of 20 k as shown in Fig. Q1. The flange of the beam is braced at its midspan and at the supports. Use the LRFD method to check if this beam is adequate or satisfactory. Take Cb=1.   
A three-span continuous beam supports 6-inch thick one-way slabs that span 20 ft center-to-center of beams....
A three-span continuous beam supports 6-inch thick one-way slabs that span 20 ft center-to-center of beams. The beams have clear spans, face-to-face of 16-in.-square columns, of 27, 30, and 27 ft. The floor supports ceiling, ductwork, and lighting fixtures weighing a total of 8 psf, ceramic floor tile weighing 16 psf, partitions equivalent to a uniform dead load of 20 psf, and a live load of 100 psf. Design the beam, using f’c = 4500 psi and fy = 60...
Two bullets of the same size, mass and horizontal velocity are fired at identical blocks, only...
Two bullets of the same size, mass and horizontal velocity are fired at identical blocks, only one is made of steel and the other is made of rubber. The steel bullet has a perfectly inelastic collision with the block, while the rubber bullet has an elastic collision. Which bullet is more likely to knock over the block, or are both equally likely to do so? Justify your choice based on physics principles. Make an initial posting before replying to other...
Two thin strips of metal are bolted together at one end and have the same temperature....
Two thin strips of metal are bolted together at one end and have the same temperature. One is steel, and the other is aluminum. The steel strip is 0.11% longer than the aluminum strip. By how much should the temperature of the strips be increased, so that the strips have the same length?
1.The Nearly Normal condition is met in one of either of two ways: the sample size...
1.The Nearly Normal condition is met in one of either of two ways: the sample size is large or... a.the population (and sample) distribution are already normal distribtuions. b.we know the standard deviation of the population. c.if the units we are measuring can only be positive (e.g. weights of chickens). d.the two samples are independent. 2.Assume there exists a sample distribution that is normally distributed. For the sampling distribution to be approximately normal the central limit theorem requires the sample...
You are offered jobs with identical responsibilities by two different firms in the same industry. One...
You are offered jobs with identical responsibilities by two different firms in the same industry. One has no debt in its capital structure, and the other has 99 percent debt in its capital structure. Will you require a higher level of compensation from one firm than from the other? If so, which firm will have to pay you more?
**Please do not write in handwriting** 1- You have two screw drivers, one with a handle...
**Please do not write in handwriting** 1- You have two screw drivers, one with a handle that is 8 cm long and 2 cm wide and the other is 8 cm long and 5 cm wide. Assume the size of the driver head is the same in each case, which one would likely be the most effective to loosen a stubborn screw? Why? 2- Discuss the following sentence: The moment of inertia of an object will be greater for a...
1. Two people work together in the same office. One smokes and the other can’t stand...
1. Two people work together in the same office. One smokes and the other can’t stand smoke. The person who smokes derives the following marginal benefit from smoking MBA(x) = 12 – x, where x is measured in cigarettes per day. The other person faces marginal costs of breathing smoke from cigarettes MCB(x) = x. It is possible to rent a “clean air” machine that reduces smoke from cigarettes in the air by 50% for $10 per day. It is...
Consider two genes with different expected mutation rates due to size. Gene 1 has a mutation...
Consider two genes with different expected mutation rates due to size. Gene 1 has a mutation rate of 1 x 10-6 in the population, while gene 2 has a mutation rate of 3 x 10-6 in the population. Assume that the probability for an individual to have two mutations in one gene is 0. Also, the number of bases, n, in a gene is large. 1. State the probability that there are more than two people with mutations total between...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT