Question

Fill in the blanks In a __________experiment, a material is pulled from each side and the...

Fill in the blanks

In a __________experiment, a material is pulled from each side and the force required to reach every distance is measured.

In a__________experiment, the force required to change each distance is still measured, but the material is instead being crushed from both sides

Homework Answers

Answer #1

* In a tensile experiment a material is pulled from each side and the force required to reach every distance is measured.

The nature of tensile force is pulling or elongation outwards. Length increases and cross section decreases. Failure will occur by breaking or necking the fibre.

* In a compression experiment the force required to change each distance is still measured but the material is instead being crushed from both sides.

The nature of compression is to push inwards so length decreases and cross section increases and failure occur by crushing.

PLEASE RATE THE ANSWER

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A uniform marble rolls down a symmetric bowl, starting from rest at the top of the...
A uniform marble rolls down a symmetric bowl, starting from rest at the top of the left side. The top of each side is a distance h above the bottom of the bowl. The left half of the bowl it rough enough to cause the marble to roll without slipping, but the right half has no friction because it is coated with oil. How far up the smooth side will the marble go, measured vertically from the bottom? How high...
Match terms to their definitions. Write the corresponding letters on the blanks. Not all terms will...
Match terms to their definitions. Write the corresponding letters on the blanks. Not all terms will be used. 1. the best appearing side of a piece of wood or the side that is exposed when installed a. backing b. eased edge 2. a wall finish applied partway up the wall from the floor c. face 3. a building product made by compressing wood fibers into sheet form d. gypsum board 4. an edge of lumber whose sharp corners have been...
Two painters are working on a platform hanging off the side of a building. The platform...
Two painters are working on a platform hanging off the side of a building. The platform is 10 meters long and supported by two cables. The painters are represented by vector forces in the free-body drawing below. The weights of the objects are: Platform 184 N, Sue 130 N, Jack 220 N. Calculate the force in each cable when the painters are in the position shown below(Case 1). To start, locate the pivot point where Cable 1 attached to the...
PLEASE FILL IN THE BLANKS WITH THE PROPER TERM! THANKS Key Terms ---------------------------------------------------------------------------------------------------------------------------- Positive relationship ---...
PLEASE FILL IN THE BLANKS WITH THE PROPER TERM! THANKS Key Terms ---------------------------------------------------------------------------------------------------------------------------- Positive relationship --- Occurs in so far as pairs of observations tend to occupy similar relative positions in their respective distribution. Negative relationship --- Occurs in so far as pairs of observations tend to occupy dissimilar relative positions in their respective distribution. Scatterplot --- a graph containing a cluster of dots that represents all pairs of observations. Person correlation coefficient --- A number between –1 and +1...
A uniform solid marble, of mass m = 20.0 g and diameter 1.00 cm, rolls without...
A uniform solid marble, of mass m = 20.0 g and diameter 1.00 cm, rolls without sliding down a large symmetric steel bowl, starting from rest at point A, at the top of the left(no-slip) side. The top of each side is a distance h = 15.0 cm above the bottom of the bowl. The left half of the bowl is rough enough to cause the marble to roll without slipping, but the right half of the bowl is frictionless...
1. Which describes the vector calculation of the Biot-Savart law?    a. The length element in...
1. Which describes the vector calculation of the Biot-Savart law?    a. The length element in the direction of the current is crossed into a vector directed from that element toward the point of measurement.    b. The length element in the direction of the current is dotted into a vector directed from that element toward the point of measurement.    c. The magnetic field vector is crossed into a vector directed from a current-length element toward the point of...
If two wires carry current next to each other, they will exert a force on each...
If two wires carry current next to each other, they will exert a force on each other. The force is caused by magnetic fields. One current creates a magnetic field, and this field exerts a force on the other current. The magnitude of the field created by a long, straight current-carrying wire is given by Equation 1 below; B= (μ0i)/(2πr) where i is the current and r is the distance from the wire. The magnitude of the force exerted on...
Item 6 In the case below, the original source material is given along with a sample...
Item 6 In the case below, the original source material is given along with a sample of student work. Determine the type of plagiarism by clicking the appropriate radio button. Original Source Material Student Version Learning is a complex set of processes that may vary according to the developmental level of the learner, the nature of the task, and the context in which the learning is to occur. As already indicated, no one theory can capture all the variables involved...
1. First consider a mass on an inclined slope of angle θ, and assume the motion...
1. First consider a mass on an inclined slope of angle θ, and assume the motion is frictionless. Sketch this arrangement: 2. As the mass travels down the slope it travels a distance x parallel to the slope. The change in height of the mass is therefore xsinθ. By conserving energy, equate the change of gravitational potential energy, mgh = mgxsinθ, to the kinetic energy for the mass as it goes down the slope. Then rearrange this to find an...
Item 6 In the case below, the original source material is given along with a sample...
Item 6 In the case below, the original source material is given along with a sample of student work. Determine the type of plagiarism by clicking the appropriate radio button. Original Source Material Student Version The theory we have constructed originates with the three phases of learning described above. We have organize and adapted the features of simulations to provide the learner with the most effective and efficient presentations in order to achieve successful acquisition, application and assessment. Our general...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT