Question

A trapezoidal channel is 6 m wide and has a side slope of 0.5 horizontal: 1...

A trapezoidal channel is 6 m wide and has a side slope of 0.5 horizontal: 1 vertical. If the
bed slope of the channel is 0.0004 and Manning’s n = 0.02, find the discharge which can
make the channel a hydraulically efficient channel section.

Homework Answers

Answer #1

comment for any doubt about this solution thank you

Don't forget to upvote if you got your answer

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A hydraulic jump is formed in a trapezoidal channel of 2.0-m bed width, 1:1 side slope,...
A hydraulic jump is formed in a trapezoidal channel of 2.0-m bed width, 1:1 side slope, and carrying a discharge of 6.0 m3/s. The initial and final depths of the jump are 0.5m and 2.0m, respectively. Concrete blocks are placed to stabilize the jump. Cf = 0.6. Construct the M-y diagram for the channel section. Find the critical depth.
7. A) Find the depth of water flowing through a triangular channel having a bed slope...
7. A) Find the depth of water flowing through a triangular channel having a bed slope of 1 in 3500 and side slope of 1:1, when it carries 1.2 m3/s. Take Manning’s Coefficient N = 0.014 B) For a most economical trapezoidal section of side slope 2h: 5V, bed slope of 1 in 2000 and C = 50. Find the rate of flow if the bottom width of the channel is 5 m.
The discharge in a channel with bottom width 3 m is 12 m3 s–1. If Manning’s...
The discharge in a channel with bottom width 3 m is 12 m3 s–1. If Manning’s n is 0.013 m-1/3 s and the streamwise slope is 1 in 200, find the normal depth if: (a) the channel has vertical sides (i.e. rectangular channel); (b) the channel is trapezoidal with side slopes 2H:1V. (Answer with steps plz)
In a trapezoidal channel with a constant width of b=3 m. and side slopes of 1:3...
In a trapezoidal channel with a constant width of b=3 m. and side slopes of 1:3 (1 vertical, 3 horizontal) and discharge rate of 6 m3 /sec, if the maximum step upward height is z=0.5 m. not to cause any choking, what is the water depth before and after this maximum step upward. Draw the water surface profile and specific energy curve (E vs y) for this flow.
a trapezoidal channel to carry 142 m³/minute of water is designed to have a minimum cross-section....
a trapezoidal channel to carry 142 m³/minute of water is designed to have a minimum cross-section. find the bottom width and depth if the bed slope is1 in 1200, the side slope at 45° and chezy's co-efficient =55
A wide rectangular channel of width 20 m and has n = 0.035, determine the critical...
A wide rectangular channel of width 20 m and has n = 0.035, determine the critical bed slope and discharge for critical depths of 0.2, 0.5 and 1.0 m
A discharge of 4.25 m3 /s occurs within a trapezoidal channel with a base width of...
A discharge of 4.25 m3 /s occurs within a trapezoidal channel with a base width of 3m, 3:1 side slopes (i.e. Z = 3), a longitudinal bed slope of 0.0009 m/m with a Manning’s roughness coefficient of 0.025 (i.e. sand). State the normal flow depth (yn) critical flow depth (yc) and the Froude Number of the flowing water.
3. a) A trapezoidal open channel is being designed to convey a discharge of 11.0 m3...
3. a) A trapezoidal open channel is being designed to convey a discharge of 11.0 m3 /sec. The channel will be excavated into clay and will have the following properties: side slope with m = 1.5, bottom slope of So = 0.001, Manning’s n = 0.022, and bottom width b = 1.0 m. For these conditions is there a risk of channel erosion? b) The earth-works contractor that will carry out the excavation suggests that the side slope angle can...
A rectangular channel 6.20 m wide and 1.20 m deep is laid on a uniform slope...
A rectangular channel 6.20 m wide and 1.20 m deep is laid on a uniform slope of 0.003. The roughness coefficient of the channel is 0.013 m. a. Determine the discharge in the channel in m3/sec. b. Determine the savings in the lining per meter length of channel if the most efficient rectangular section is to be used for the same flow and properties. c. Determine the savings in earth excavation per meter length of channel if the most efficient...
A trapezoidal concrete channel (n = 0.015) has side slopes of 2H:1V, a bottom width of...
A trapezoidal concrete channel (n = 0.015) has side slopes of 2H:1V, a bottom width of 10.0 ft, and a longitudinal slope of 0.005. (a) Compute the discharge rate (in cfs) and velocity (ft/s) when the water depth is 3.0 ft. (b) Compute normal depth and critical depth (in feet) for a discharge rate of 300 cfs.
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT