Question

sheer strength test,test control soil

sheer strength test,test control

soil

Homework Answers

Answer #1

Shear strength test is used for determining the shear strength of the soil. Various experiments are being done in labs to determine the shear strength. It is a very important parameter of soil which will tell about the load it can bear at the time of construction. These may be of few types :

  • Vane Shear Test
  • Direct Shear Test

Vane Shear Test : This test is being used for determining the undrained stress of the cohesive soils. The shear determined here is very low around 0.5 kgf/cm2. The remolded strengths used here are being used for evaluating the sensitivity of soil.

Direct Shear Test : Direct Shear Test is being done to determine the strength of undisturbed or remolded samples. It is the most common technique used for determining the stress of the soil. The shear in this test is being determined by Mohr Failure criteria.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Shear strength measurements derived from unconfined compression tests for two types of soil gave the results...
Shear strength measurements derived from unconfined compression tests for two types of soil gave the results shown in the following table (measurements in tons per square foot). Soil Type I Soil Type II n1 = 30 n2 = 35 y1 = 1.69 y2 = 1.46 s1 = 0.24 s2 = 0.22 Do the soils appear to differ with respect to average shear strength, at the 1% significance level? State the null and alternative hypotheses. H0: μ1 = μ2 Ha: μ1...
Explain the process of dilation in relation to shear strength in soil.
Explain the process of dilation in relation to shear strength in soil.
The soil strength properties of a saturated soil specimen are known as: CUU = 35 kPa,...
The soil strength properties of a saturated soil specimen are known as: CUU = 35 kPa, ϕUU = 0֯; Ccu = 12 kPa, ϕcu = 12֯; C’ = 3 kPa, ϕ’ = 28֯. The shear stress on the potential failure plane is _________kPa when the maximum principal stress is 400 kPa, the minimum principal stress is 250 kPa and the pore water pressure is 160 kPa. (Hint: σ 1 ′ = σ 3 ′ K P + 2 c ′...
A cohesive soil sample tested in an unconfined compression test failed by developing a failure plain...
A cohesive soil sample tested in an unconfined compression test failed by developing a failure plain when the axial load on the sample was 193 N. Determine the undrained shear strength, Cu (kPa) of the soil given the original diameter of the sample was 45 mm and the strain at failure was 9%. Provide your answer in kPa as a whole number.
: Which method of soil test is preferred as an Engineer to determine the density of...
: Which method of soil test is preferred as an Engineer to determine the density of soil in the construction site? What is the difference in the procedure in doing the soil test for determining the dry density and bulk density of soil?
a) A Standard Penetration Test (SPT) is conducted to measure the in situ strength of A-7-6...
a) A Standard Penetration Test (SPT) is conducted to measure the in situ strength of A-7-6 subgrade soil. The number of blows required to drive the split spoon sampler into the ground were as follows b) The maximum dry density for a soil obtained in the lab at 11% moisture content is 122.4 pcf If the measured field bulk density was 131.6 pcf at 10% water content, what is the percent compaction achieved for this soil in the field? C)...
What are the mechanisms of soil erosion? What are conservation practices to control both water and...
What are the mechanisms of soil erosion? What are conservation practices to control both water and wind erosion?
Contraction Strength Assessment. Explain how your nerves control skeletal muscle to change the strength of contraction:...
Contraction Strength Assessment. Explain how your nerves control skeletal muscle to change the strength of contraction: Part A. During a weak voluntary movement. Part B. During a strong voluntary movement
A soil test indicates that the pH of a soil is 5.5.  For grass to thrive, the...
A soil test indicates that the pH of a soil is 5.5.  For grass to thrive, the pH must be raised to 6.5.  From a chart on the bag, you discover that 80 lbs of lime per 1,000 sq ft are required to raise the pH from 5.5 to 6.5.  Determine how many bags of lime that you need to buy for a residential property that has a 140 X 120 front lawn and a 120 X 120 back lawn.  Lime comes in 50...
The quality control manager of a tire company wishes to estimate the tensile strength of a...
The quality control manager of a tire company wishes to estimate the tensile strength of a standard size of rubber used to make a class of radial tires. A random sample of 61 pieces of rubber from different production batches is subjected to a stress test. The test measures the force (in pounds) needed to break the rubber. According to the sample results, the average pressure is 238.4 pounds with a population standard deviation of 35 pounds. Determine the 98%...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT