Question

9) An existing rural freeway in level terrain is to be analyzed to determine LOS using...

9) An existing rural freeway in level terrain is to be analyzed to determine LOS using the following information: number of lanes in each direction equals 2, peak hour volume of 2140 veh/h (in the peak direction), 15% trucks, 2% recreational vehicles, PHF = 0.90, lane width = 12 ft, lateral clearance = 10 ft, average interchange spacing is 3 mi.

Homework Answers

Answer #1

Gven hat ed to cetermine Les usi Lateral cleaanceo t Δ lanes ?n each direckic ehwals Q, . dir echbr hour volturne c 5trucks , a.f. recrenhone vehicles+ S frr eroi ex Can Corm pered usirguat US?n Tab q.25 HR =

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Determine Level of Service an urban freeway section, if the BFFS = 70 mph. The data...
Determine Level of Service an urban freeway section, if the BFFS = 70 mph. The data are as follows: Number of lanes: 4 (one direction) Lane width = 12 ft. Lateral clearance =5 ft. (right side) Interchange density = 1 per mile Percent trucks = 14 Percent RVs = 4 PHF = 0.95 Commuter traffic
An urban circumferential freeway is to be designed on the basis of the following information: design...
An urban circumferential freeway is to be designed on the basis of the following information: design year average annual daily traffic, AADT = 75,000 veh/day; the estimate of the percent of traffic occurring during the peak-hour is 9%; the percent of peak-hour traffic in the heavier direction is estimated to be 55%. The traffic mixture is expected to be similar to the current mixture of 7% trucks, 3% buses and no recreational vehicles. The PHF is estimated to be 0.9....
A long segment of the suburban freeway is to be designed on level terrain. The level...
A long segment of the suburban freeway is to be designed on level terrain. The level segment, however, is followed by a 4.5% grade, 2.0 miles in length. If the DDHV is 2,500 veh/h with 15% trucks (standard mix), how many lanes will be needed on the (a) upgrade, (b) downgrade, (c) level terrain segment to provide for the level of service C? Lane widths and lateral clearances may be assumed to be 12 ft and 6 ft, respectively. Ramp...
A section of a freeway on rolling terrain has the following properties: design hourly volume =...
A section of a freeway on rolling terrain has the following properties: design hourly volume = 2500 vph, 10% trucks, 2% RVs, PHF = 0.95, two lanes 12 ft wide each, 5 ft lateral clearance and 8 ramps in every 10 miles. Determine the Level of Service (LOS) of the section according to the Highway Capacity Manual 2010.
A freeway segment has the following characteristics: 3 lanes in each direction Lane width = 11...
A freeway segment has the following characteristics: 3 lanes in each direction Lane width = 11 ft Right shoulder width (lateral clearance) = 4 ft There is 1 interchange within 3 miles downstream, and 2 interchanges within 3 miles upstream. The freeway is located on a level terrain and has 10% of heavy vehicles in the traffic stream. Calculate the free-flow speed (FFS) for this freeway segment using the HCM formula (FFS = 75.4 – fLW – fLC – 3.22TRD0.84).
A four-lane freeway (two lanes in each direction) in rolling terrain has a peak 15-min flow...
A four-lane freeway (two lanes in each direction) in rolling terrain has a peak 15-min flow rate of 1800 veh/h during the peak hour. The traffic stream contains 6% trucks, 3% buses, and 5% recreational vehicles. What is the analysis flow rate (i.e., the peak 15-min demand flow rate under equivalent base conditions in pc/h/ln)?
Answer the following question about a basic freeway segment based on Highway Capacity Manual 2016 (assume...
Answer the following question about a basic freeway segment based on Highway Capacity Manual 2016 (assume right-hand traffic and use U.S. customary units): A six-lane freeway (three lanes in each direction) operates at the maximum service flow rate (MSF) of LOS D conditions during the peak hour with an observed demand volume of 3500 veh/h (one direction). The free flow speed (FFS) of the freeway is estimated to be 65 mi/h. The freeway is on rolling terrain and the traffic...
A six-lane freeway is being designed for a location in rolling terrain. The expected free- flow...
A six-lane freeway is being designed for a location in rolling terrain. The expected free- flow speed is 65 mph. Lane widths will be 12 ft and right shoulder widths will be 6 ft. During the peak hour, it is expected there will be a directional peak- hour volume of 2700 vehicles with 12% heavy vehicles in the traffic stream. The PHF is expected to be 0.90. Determine level of service.
An eight-lane freeway (four lanes in each direction) is on rolling terrain and has 11-ft lanes...
An eight-lane freeway (four lanes in each direction) is on rolling terrain and has 11-ft lanes with a 4- ft right-side shoulder. The total ramp density is 1.5 ramps per mile. The directional peak-hour traffic volume is 5400 vehicles with 11% heavy vehicles. The peak 15-minute volume is 1421 vehicles. What are the freeway’s density and level of service
A six-lane divided multilane highway (three lanes in each direction) has a measured free-flow speed of...
A six-lane divided multilane highway (three lanes in each direction) has a measured free-flow speed of 50 mi/h. It is on mountainous terrain with a traffic stream consisting of 7% large trucks and buses and 3% recreational vehicles. The driver population adjustment in 0.92. One direction of the highway currently operates at maximum LOS C conditions and it is known that the highway has PHF=0.90. 1. Determine the hourly volume for these conditions. 2. How many vehicles can be added...