Question

A 100 ft steel tape of cross-sectional area 0.0025 in2, weight 2.0 lb, and standardized at...

A 100 ft steel tape of cross-sectional area 0.0025 in2, weight 2.0 lb, and standardized at 68°F is 99.983 feet between end marks when supported throughout under a 10-lb pull.

a. What is the true horizontal length of a recorded distance AB if AB was measured to be 140.23 ft? At the time of measurement, the average temperature was 55°F, the tape was unsupported and there was 17 lbs of tension on the tape. (Assume horizontal taping and all full tape lengths except the last.)

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
A 100-ft steel tape standardized at 68°F and supported throughout under a tension of 12 lb...
A 100-ft steel tape standardized at 68°F and supported throughout under a tension of 12 lb was found to be exactly 100.010 ft long. The tape had a cross-sectional area of 0.0075 in2 and a weight of 2.25 lb. This tape is to be used to layout a distance AB of 529.81 ft under the following conditions: 95°F, supported throughout, tension of 20 lb. What length is required to layout the specified distance?
A 100-ft steel tape standardized at 68°F and supported throughout under a tension of 12 lb...
A 100-ft steel tape standardized at 68°F and supported throughout under a tension of 12 lb was found to be exactly 100.010 ft long. The tape had a cross-sectional area of 0.0075 in2 and a weight of 2.25 lb. This tape is to be used to layout a distance AB of 529.81 ft under the following conditions: 95°F, supported throughout, tension of 20 lb. What length is required to layout the specified distance? ANSWER IS NOT 529.72
You are measuring a line with a steel tape that has a standardized length equal to...
You are measuring a line with a steel tape that has a standardized length equal to 100.000 feet and a weight of 2.25 lb. Three full tape lengths and one partial length were used when making the measurement, resulting in a recorded length of 389.28 ft. The tape was supported at ends only and a pull of 12 pounds was used. What is the distance after being corrected for sag?
4. A 50-m tape of standard length has a weight of .05kg/m, with a cross-sectional area...
4. A 50-m tape of standard length has a weight of .05kg/m, with a cross-sectional area of 0.04 sq.cm. It has a modulus of elasticity of 2.10x106 kg/sq.cm. The tape is of standard length under a pull of 5.5 kg when supported throughout its length and a temperature of 20°C. This tape was used to measure a distance between A and B and was recorded to be 458.65m. long. At the time of measurement the pull applied was 8 kg....