Question

MATERIAL SCIENCE QUESTION You are designing a cylindrical rod of metal and the plastic deformation is...

MATERIAL SCIENCE QUESTION
You are designing a cylindrical rod of metal and the plastic deformation is not allowerd. Find the minimum diameter of the rod to carry a load of 200kn tension under Factor of safetkg of 1.5. The yield strength of the metal is 272.1938Mpa. After design, how much of the rod is going to elongate if the original length is 100mm. Modulus of elasticity = 403.2501GPa

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Problem. A cylindrical specimen of a hypothetical metal having a diameter of 7.671 mm and a...
Problem. A cylindrical specimen of a hypothetical metal having a diameter of 7.671 mm and a gauge length of 251.905 mm is pulled in tension. Use the load–elongation characteristics shown in the following table to complete parts (a) through (f). (a) Plot the data as stress (MPa) versus strain (b) Compute the modulus of elasticity in GPa (c) Determine the yield strength at a strain offset of 0.002 (d) Determine the tensile strength of this alloy (e) What is the...
The elastic modulus, yield strength and ultimate strength of a certain material are 110 GPa, 240...
The elastic modulus, yield strength and ultimate strength of a certain material are 110 GPa, 240 MPa and 265 MPa, respectively. If a cylindrical bar of this material 380 mm long is subjected to a uniaxial tension test and its length is increased by an amount of 0.50 mm under a tensile load of 6660 N. At the same time its diameter decreased by 0.28 mm. Calculate; a) The initial diameter of the bar,
Commercial hose connectors used for watering and irrigation are sold in variety of sizes and shapes....
Commercial hose connectors used for watering and irrigation are sold in variety of sizes and shapes. The cost of such connector depends on the cost of material from which it is made and some other design limitations. Using the following information: Tensile load imposed on the connector is 20,000 N. Deformation of the connector is purely elastic. Outer diameter (OD) of the connector is 20 mm. Length of the connector is 30 mm. Inner diameter (ID) of the connector is...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT