Question

Scrutinize the 13C NMR spectrum of the methyl 3-nitrobenzoate If you had not kept watch over...

Scrutinize the 13C NMR spectrum of the methyl 3-nitrobenzoate

If you had not kept watch over the reaction temperature, how might this affect the 13C NMR of the product isolated from this reaction?

(Hint: what product is likely to be obtained at higher reaction temperature?)

Science   Chemistry   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

Information about the reaction is not gien. I am suspecting it is amout the nitration of methyl benzoate.

In this reaction if temperature is properly conroled, mono nitration takes place and if the teperature is not controled and it is increased, at the high temperature there is an high possiblity of di nitration .

When there is only one nitro group in the molecule, we see total 8 signals or lines in the corresponding 13 C NMR spectrum.

If a second nitration happens the molecule will certainly become symmetrical and the number of peaks in the 13C=s[ectrum decreases to 6.

Two predicted spectra are given .

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
In an 1H NMR spectrum using CDCl3, you observe a broad peak at 1.5ppm that is...
In an 1H NMR spectrum using CDCl3, you observe a broad peak at 1.5ppm that is not related to your product and integrates for 2.6 Hs relative to a methyl group. What could be responsible for this peak and what might this indicate about your sample?
How could you determine whether you had complete conversion of tripalmitin to methyl palmitate? What differences...
How could you determine whether you had complete conversion of tripalmitin to methyl palmitate? What differences would you predict in the proton NMR spectrum of pure methyl palmitate vs. a mixture of tripalmitin and methyl palmitate?
** synthesis of p-nitroaniline Based on the melting point of the recrystallized product, can you verify...
** synthesis of p-nitroaniline Based on the melting point of the recrystallized product, can you verify that the major product of the reaction was indeed p-nitroacetanilide? If you were to perform a TLC analysis of your crude product, how would you know if some of your product had undergone hydrolysis? (Hint: How many spots might you see, and what might their Rf values indicate regarding their polarities? Refer to your answer to Pre-Lab Q 4b) In which region of the...
Alkene Hydration LAB 3.    Choose the starting materials: styrene, and water, which is the solvent. 4.    Return to...
Alkene Hydration LAB 3.    Choose the starting materials: styrene, and water, which is the solvent. 4.    Return to the lab and build the experiment apparatus, which includes a heater, condenser, nitrogen gas. 5.    Add the reagent, sulfuric acid (H2SO4) to the reaction flask. 6.    You will monitor the reaction progress using the pull down TV and TLC. QUESTION 1 The product produce when styrene is reacted with sulfuric acid in the presence of water is a. benzoic acid b. phenol c. 1-phenylethanol d. 2-phenolethanol...
For your post-lab questions: some of you made red-colored Co(salen), while others made brown-colored Co(salen). The...
For your post-lab questions: some of you made red-colored Co(salen), while others made brown-colored Co(salen). The difference is due to different amount of O2 incorporated into the reaction to make (salen)Co-O-O-Co(salen). The red compound has less O2 and usually forms when the temperature is higher. (1) Why you did not see the same phenomenon last week for the synthesis of Ni(salen)? (2) Why higher temperatures favor the product with less O2 incorporated? (3) Assuming you made pure (salen)Co-O-O-Co(salen), how would...
1) If you had not dried the solid, would the calculated percent yield have been higher,...
1) If you had not dried the solid, would the calculated percent yield have been higher, lower, or unchanged? Explain 2)Boron trichloride is prepared from the following reaction. 2B2O3 + 6Cl2 + 3C --> 4BCl3 + 3CO2 If 8.254g of B2O3 is mixed with 4.446g of Cl2 and 4.115g of C then answer the following questions.    2a) What is the theoretical yield of boron trichloride in grams? 2b) How much of each of the excess reagents with remain once...
1)At 25°C, some second-order reaction 3 X (g)→ 2 Y (g) + Z (g) has a...
1)At 25°C, some second-order reaction 3 X (g)→ 2 Y (g) + Z (g) has a half-life of 5.82 hours when the initial concentration of X is 4.46 M. (a) What is rate constant for this reaction? (b) How much X will be left after 17.5 hours? Example of answer: (a) k = [type your answer] M–1 h–1; (b) [X]t = [type your answer] M. 2) For some second-order reaction: 3 X (g)→ Y (g) + Z (g). The following...
B.N., a 41-year-old female who is a dental hygienist, has had several surgeries over the past...
B.N., a 41-year-old female who is a dental hygienist, has had several surgeries over the past five years due to a knee injury. She presents to the outpatient surgery department today for her last reconstructive surgery. Her past medical history indicates she had asthma as a child and had one occurrence of contact dermatitis. She tells you she has no known drug allergies. You start B.N.’s IV and perform a saline flush. Within three minutes, B.N. states that her IV...
What was the reason for the addition of H2O (10 ml), followed by gentle heating? Draw...
What was the reason for the addition of H2O (10 ml), followed by gentle heating? Draw a mechanism equation for the reaction taking place. Why was the water added slowly and through the condenser? Here is my experiment... Experimental procedure Warning: acetic anhydride is corrosive and a lachrymator. When carrying it across the lab, when it is inside a flask, please temporarily stopper the flask. Reaction Place salicylic acid (200 mg = 0.200g) into a dry 25ml round bottom flask...
1. What would you predict to be the consequence on DNA replication if the cell had...
1. What would you predict to be the consequence on DNA replication if the cell had a non-functional primase protein? A. There would be no leading strand made. B. There would be no lagging strand made. C. There would be gaps in the leading strand. D. There would be gaps in the lagging strand. E. Two of the above are true. 2. During a laboratory experiment, you discover that an enzyme-catalyzed reaction has a ∆G of -20 kcal/mol. If you...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT