Question

What is the concentration in (a) ppmv and (b) percent by volume, of carbon monoxide (CO)...

What is the concentration in (a) ppmv and (b) percent by volume, of carbon monoxide (CO) with a concentration of 103 micrograms/m3? Assume a temperature of 25 degrees celcius and total pressure of 1 atm.

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Based on the "national ambient air quality objectives", the acceptable hourly average concentration of carbon monoxide...
Based on the "national ambient air quality objectives", the acceptable hourly average concentration of carbon monoxide (CO) is 35mg/m^3. Find the acceptable concentration of CO in ppm if the temperature is -30'C and pressure is 0.92 atm. Express the concentration as a percent by volume.
A tank with a volume of 8.6 ft3 contains 5.36 lbmol of carbon monoxide (CO) gas...
A tank with a volume of 8.6 ft3 contains 5.36 lbmol of carbon monoxide (CO) gas at a pressure of 3500 lbf/in.2 Determine the temperature, in °R. Determine the percent error in temperature of assuming ideal gas behavior at this state for CO. Please provide the complete answer.
Carbon monoxide and oxygen are in equilibrium at 1 atm, expressed as: co + 0,5 02...
Carbon monoxide and oxygen are in equilibrium at 1 atm, expressed as: co + 0,5 02 → CO2. The partial pressure for oxygen is 0,004 atm and for carbon monoxide is 0.008 atm. The chemical equilibrium constant is assumed to be 0,122. Determine a. Partial pressure of CO2 b. Ppm of CO2
The concentration of carbon monoxide in an urban apartment is 48 micrograms/m^3. What mass of carbon...
The concentration of carbon monoxide in an urban apartment is 48 micrograms/m^3. What mass of carbon monoxide in grams is present in a room measuring 10.6 ft x 14.8 ft x 20.5 ft ?
a power plant gas emission contains 17.4% carbon dioxide by volume. Measurements in the discharge stack...
a power plant gas emission contains 17.4% carbon dioxide by volume. Measurements in the discharge stack indicate a temp of 83.5 °C and pressure of 1 atm. A) what is the CO2 concentration in unit of ppmv? B) what is the partial pressure of CO2 In atm? C) what is the CO2 Concentration in g/m^3?
The molar heat capacity for carbon monoxide at constant volume is CV,m = 20.17 J/(K·mol). A...
The molar heat capacity for carbon monoxide at constant volume is CV,m = 20.17 J/(K·mol). A 13.00-L fixed-volume flask contains CO(g) at a pressure of 3.00 kPa and a temperature of 25.0 °C. Assuming that carbon monoxide acts as an ideal gas and that its heat capacity is constant over the given temperature range, calculate the change in entropy for the gas when it is heated to 800.0 °C.
What volume of hydrogen gas is produced when 0.685 mol of carbon monoxide reacts completely according...
What volume of hydrogen gas is produced when 0.685 mol of carbon monoxide reacts completely according to the following reaction at 0°C and 1 atm? carbon monoxide ( g ) + water ( l ) carbon dioxide ( g ) + hydrogen ( g ) =_________ liters of hydrogen gas?
1.     The exhaust of an automobile is found to contain 2% CO, at a temperature of...
1.     The exhaust of an automobile is found to contain 2% CO, at a temperature of 80°C. Express the concentration of CO in the exhaust in mg m-3. 2.     California’s air quality standard for nitrogen dioxide (NO2) is 470mg m-3 (at a temperature of 25°C and 1 atm of pressure). Express the concentration in ppmv.
CO(g)+Cl2(g)⇌COCl2(g) Carbon monoxide and chlorine gas are allowed to react in a sealed vessel at 464...
CO(g)+Cl2(g)⇌COCl2(g) Carbon monoxide and chlorine gas are allowed to react in a sealed vessel at 464 ∘C . At equilibrium, the concentrations were measured and the following results obtained: Gas Partial Pressure (atm) CO 0.780 Cl2 1.22 COCl2 0.120 What is the equilibrium constant, Kp, of this reaction? Part B The following reaction was performed in a sealed vessel at 767 ∘C : H2(g)+I2(g)⇌2HI(g) Initially, only H2 and I2 were present at concentrations of [H2]=3.75M and [I2]=2.05M. The equilibrium concentration...
carbon monoxide is to be burned with air at atmospheric pressure to produce a gad containing...
carbon monoxide is to be burned with air at atmospheric pressure to produce a gad containing an equal number of moles of CO and CO2 . The products of combustion leave the furnace at 4400F. If the only significant reaction is the oxidation of CO and CO2, what is the composition of the gas leaving the combustion chamber? You may assume equilibrium at the combustion chamber exit and the equilibrium at this condition is 6 atm^-1/2.
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT