Question

Why did we use 0.5% glacial acetic acid in ethyl acetate instead of 70:30 hexane/acetone for...

Why did we use 0.5% glacial acetic acid in ethyl acetate instead of 70:30 hexane/acetone for TLC development solvent?

Homework Answers

Answer #1

Dear Student, Kindly refer to the complete solution. Feel free to ask if you face difficulty in understanding even a single line of the solution attached, so that we can assist you in a better way.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Br2 dissolves in a number of solvents, but we preferentially use glacial acetic acid. Explain why...
Br2 dissolves in a number of solvents, but we preferentially use glacial acetic acid. Explain why acetic acid is a good solvent for electrophilic bromination reactions. (Is it polar protic, polar aprotic or non-polar? How might that be important in this reaction?)
Which solvent system is more polar 30% Acetone/70% Hexane OR Ethanol? How would you be able...
Which solvent system is more polar 30% Acetone/70% Hexane OR Ethanol? How would you be able to tell this from a column chromatography? I am just confused about this. I think that it would be Ethanol. But I am unsure how to tell that from the column chromatography because wouldn't the more polar solvent take the beta carotene with it instead of the chlorophyll?
Thursday ) 250 kg ethanol reacts with 250 kg acetic acid to form ethyl acetate and...
Thursday ) 250 kg ethanol reacts with 250 kg acetic acid to form ethyl acetate and water according to the following reaction : CH , OH + CHCOOH , CH COOCH + H2O The fractional conversion of the limiting reactant obtained at the end of the process is 0 . 30 . ( a ) What is the limiting reactant ? ) Calculate the percent excess reactant . ( c ) Calculate the extent of reaction ( d ) Calculate...
We need to make a flow chart, then use extraction and recrystallization to isolate component to...
We need to make a flow chart, then use extraction and recrystallization to isolate component to purify. What should we use as a solvent to spot on a thin layer chromatography silica plate? , Solvents: acetone, ethanol, methanol, ethyl acetate, hexanes, dichloromethane Aqueous solutions: 1M NaOH, 1M HCl, 3M NaOH, 3M HCl, 1 M NaHCO3, saturated NaCl Drying Agent: sodium sulfate During an oxidation of benzyl alcohol to benzoic acid, a student did not have adequate time during the lab...
Why do we use sulfuric acid rather than HX acid for a dehydration reaction? What product...
Why do we use sulfuric acid rather than HX acid for a dehydration reaction? What product might have been isolated if an HX acid was used instead?
Oxidation of Methoxyacetophenone to Anisic Acid 1. Why did you lower the pH of the reaction...
Oxidation of Methoxyacetophenone to Anisic Acid 1. Why did you lower the pH of the reaction mixture to 2, rather than to some higher pH? 4. Why did we use bleach as our source of chlorine, rather than chlorine itself? 5. Iodine could have been used instead of chlorine. How much iodine would have been required to do the reaction is we use 1 gram?
Why couldn’t you use acid-base extraction to separate a ketone and an alcohol? why do we...
Why couldn’t you use acid-base extraction to separate a ketone and an alcohol? why do we use column chromatography instead? explain the benefits of both methods and why one is preferred over the other.
We are doing a synthesis lab of isopentyl acetate (bannana oil) 1.When heating to form isoamyl...
We are doing a synthesis lab of isopentyl acetate (bannana oil) 1.When heating to form isoamyl acetate, the major reason why we did not use a thermometer to monitor the temperature was? Select one: a. A reflux cannot get hotter than the boiling point of the solvent. b. The water jacket prevents solvent from boiling out. c. Boiling chips prevent bumping. d. Nothing was being distilled out of the flask. e. We did not use a Claisen adpator to prevent...
In this case ,Why do we use the left-tailed hypothesis instead of the right-tailed hypothesis?When do...
In this case ,Why do we use the left-tailed hypothesis instead of the right-tailed hypothesis?When do we use the right-tailed hypothesis and when do we use the left-tailed hypothesis? Explain only the above two questions and do not need to answer the following questions. Thanks!! During the period 1990-1998 there were 46 Atlantic hurricanes, of which 19 struck the United States. During the period 1999-2006 there were 70 hurricanes, of which 45 struck the United States. (a) State the hypotheses...
1.) You will work with 0.10 M acetic acid and 17 M acetic acid in this...
1.) You will work with 0.10 M acetic acid and 17 M acetic acid in this experiment. What is the relationship between concentration and ionization? Explain the reason for this relationship 2.) Explain hydrolysis, i.e, what types of molecules undergo hydrolysis (be specific) and show equations for reactions of acid, base, and salt hydrolysis not used as examples in the introduction to this experiment 3.) In Part C: Hydrolysis of Salts, you will calibrate the pH probe prior to testing...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT