Question

If you are making 100mL of a 0.1M HEPES buffer starting from HEPES in the basic...

If you are making 100mL of a 0.1M HEPES buffer starting from HEPES in the basic form, is it prudent to get 50mL of 1M HCl from the community reagent bottle to use for your titration?

**determine if 50mL is too much using a calculation

Homework Answers

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
-If you make up a solution of 100mL of 0.1M Hepes in the basic form, what...
-If you make up a solution of 100mL of 0.1M Hepes in the basic form, what will be the pH? -Now you add 3mL of 1M HCl to the solution above, now what will by your pH? -what can you conclude about the effect of dilution on the pH of a buffer?
If you were preparing a series of two 10% dilutions of pretend 1M HCl. You would...
If you were preparing a series of two 10% dilutions of pretend 1M HCl. You would have 3 test tubes labeled, 1, 2 and 3. Test tube 1 would be filled with 10 mL of the 1 M HCL. Always Add Acid to Water. This rule must be followed in order to prevent splattering of the acid. Use the formula to determine how much water should be added to test tube #2 to prepare a 10% dilution. The final desired...
You must give your answer by starting from basic physics concept and formula, step by step...
You must give your answer by starting from basic physics concept and formula, step by step in detail Two point charges q1 and q2 in a x-y coordinator. q1 has a charge of -3nC and located at (-2m, 0), q2 has a charge of 5nC and located at (1m, 0). Calculate following: A) electrical potential at (-1m, 0) B) electrcal field at (-1m, 0) C) if a third charge q3 of -2nC is located at (-1m, 0) position, what is...
In experiment five, the "Identification of Ions in Salts", you will use a series of reactions...
In experiment five, the "Identification of Ions in Salts", you will use a series of reactions to identify a cation in one unknown and a cation-anion in another unknown. In this experiment primarily precipitation reactions or dissolving of precipitates will be used. The color and texture of the precipitate will be important to observe. In the identification of the anion the formation of a gas will be used to help ID the anion and a flame test will be used...
Assuming you weighed out a 2.3684 g sample of your unknown, and dissolved and diluted it...
Assuming you weighed out a 2.3684 g sample of your unknown, and dissolved and diluted it as in the procedure below, and it took 35.63 mL of a 0.1025 M HCl titrant to reach the endpoint, what are the weight percents of Na2CO3 and NaHCO3 in your unknown sample? Hints: -Set g Na2CO3 = X -Eqn A: bicarbonate + carbonate = diluted weighted mass (remember, the mass is not 2.3684, you diluted it before you titrated it.Calculate the diluted g...
Determine the value of the rate constant for the hydrolysis of ethyl lactate from the following...
Determine the value of the rate constant for the hydrolysis of ethyl lactate from the following data. It was collected using exactly the same procedure as you will in the lab. Mass of ethyl lactate (grams): 0.5554 Concentration of stock HCl solution (M): 0.00985 Standardization titration volumes (of NaOH): Run Vi (mL) Vf(mL) 1 3.22 18.20 2 18.20 33.12 3 33.12 48.02 Kinetics data: Run Reaction time (seconds) Vi(mL) Vf(mL) 0 0 1 304 1.34 3.36 2 707 3.36 7.08...
After your frustration with tissue culture, you finally get your cells passaged and decide to set...
After your frustration with tissue culture, you finally get your cells passaged and decide to set up your cDNA synthesis reaction, PCR, and agarose gel. You have extracted RNA from your cells, and now you need to proceed with the cDNA synthesis. The first step is to determine the concentration of your RNA. You dilute your RNA 1:250, vortex it, move it to the cuvette, and run it on the spectrophotometer.   The spec tells you that your concentration of RNA...
What are standard conditions of ΔH° for the data you will use? Temperature 0 K 100...
What are standard conditions of ΔH° for the data you will use? Temperature 0 K 100 K 273 K 298 K Pressure 1.0 Pa 100 Pa 1.0 bar 100 bar Concentration 1.0 g/L 1.0 mol/L 1.0 mg/L mol/kg Select the complete reactions (including phases) for the reaction between solid NaOH and a solution of HCl. 2NaOH(s) + HCl(aq) → 2NaCl(aq) + H2O(l) NaOH(s) + HCl(aq) → NaCl(aq) + H2O(l) NaOH(s) + HCl(aq) → NaCl(s) + H2O(l) Calculate the theoretical ΔH°r...
Lab 9 – Molecular Biology In this lab, you will prepare an agarose gel and use...
Lab 9 – Molecular Biology In this lab, you will prepare an agarose gel and use gel electrophoresis to compare the size of 2 dye molecules Methyl orange and Ponceau G. You will also analyze an “unknown” sample that contains a mixture of two dyes. Dye molecules with lower molecular weight or greater electrical charge will migrate faster through the gel, than dye molecules with greater molecular weights or lesser electrical charge. Materials: Mini gel electrophoresis chamber 6 Tooth comb...
Case: You have recently been hired as an OR nurse at Community Hospital. Recently divorced and...
Case: You have recently been hired as an OR nurse at Community Hospital. Recently divorced and the mother of two very small children, you were thrilled and relieved to get a job with these hours at the only hospital in this small mid-western city. However, on your second day, you are confronted with an unusual situation. A 35-year-old woman is scheduled to undergo the surgical removal of a benign uterine tumor. While preparing for surgery, you discover that the two...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT