Question

The plates you are using for this lab will be autoclaved to completely sterilize them. The...

The plates you are using for this lab will be autoclaved to completely sterilize them. The measures taken to disinfect the tabletops (the source of organisms in plate 2and 3) are not as extreme. Why?

Homework Answers

Answer #1

ANSWER: Plates should have higher organism growth than bench tops, because the bench tops have no media.Tabletop- less nutrients, less density Petri dishes- high nutrients, high density.

The agar plates were used to grow bacteria on them they have become a bio-hazard. The tabletop is easily disinfected with alcohol or many other sterilizing agent. Depending on which the agar plate is made of it may be reusable and if you dont want them to be contaminated for the next experiment they need to be autoclaved.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
This is part of our lab where we put styrafoam plates on a Van de Graaf...
This is part of our lab where we put styrafoam plates on a Van de Graaf generator: STATION 2: Styrofoam plates. Observe the plates on the board. They were placed there after rubbing their back sides on the VdG generator. Notice that if it’s not too humid, that you can take them off and put them back again There is obviously no adhesive holding them there. Q5) How are they sticking? Would just any Styrofoam plate stick to the board?...
What is the most common opportunistic skin bacteria? Why do we use MSA plates in the...
What is the most common opportunistic skin bacteria? Why do we use MSA plates in the handwashing lab? What kind of bacteria does it select for? What kind of bacteria is it differential for? How does it show itself differential? Why do bacterial numbers increase after washing hands with bar soap alone or with bar soap and sterile scrub brush? Where do disposable bacterial plates go when you are done with them? What do you if you spill a bacterial...
plate D had 124 CFU’s. You will need to look back at the lab and determine...
plate D had 124 CFU’s. You will need to look back at the lab and determine what dilution was used to make plates C & D and how much was plated. Using the calculation in the lab, calculate the CFU’s per ml:
Post-Lab: Effectiveness of Hand Washing 1. What was the purpose of this exercise? 2. Which treatment...
Post-Lab: Effectiveness of Hand Washing 1. What was the purpose of this exercise? 2. Which treatment resulted in the highest number of colonies, indicating that it did NOT remove very many microbes? Did you expect this result? Why or why not? 3. Did each hand washing treatment appear to result in the same type of organisms growing on the plate? How can you tell? Why might you have seen differences? 4. Do you think that your hands were “sterile” after...
Lab: effect of copper (cucl2) on the enzyme activity in bacteria grown on agar plate using...
Lab: effect of copper (cucl2) on the enzyme activity in bacteria grown on agar plate using LB broth 1) How would you measure the cell viabilty? 2). Prepare a protocol to measure enzyme activity 3). Prepare a brief protocol to excise a protein spot and prepare your sample for analysis by mass spectrometry
Lab 6: Taxonomy INSTRUCTIONS: ·      On your own and without assistance, complete this Lab 6 Answer Sheetelectronically...
Lab 6: Taxonomy INSTRUCTIONS: ·      On your own and without assistance, complete this Lab 6 Answer Sheetelectronically and submit it via the Assignments Folderby the date listed in the Course Schedule(under Syllabus). ·      To conduct your laboratory exercises, use the Laboratory Manual located under Course Content. Read the introduction and the directions for each exercise/experiment carefully before completing the exercises/experiments and answering the questions. ·      Save your Lab 6 Answer Sheetin the following format:  LastName_Lab6 (e.g., Smith_Lab6). ·     You should submit your document as a...
Developmental biology lab questions.. Chick Embryo b. What does this suggest about the developmental of different...
Developmental biology lab questions.. Chick Embryo b. What does this suggest about the developmental of different tissue and organ system? At that point can you identify all the major body features of the bird? Is there a point where you could not identify the taxonomic group of your embryo? Study question 3. The Lab manual discusses why chicken, fish, and amphibians are ideal organisms to study developmental biology. Using the reserse logic, discuss two developmental characteristics which would make an...
1. I need to know how many cells/mL are in a culture, and I decide to...
1. I need to know how many cells/mL are in a culture, and I decide to do a plate count. I make dilutions and plate 0.1 mL of each dilution on to TSA plates. I count 20 colonies on a 10-4 dilution plate. How many cells (CFU’s) per mL are likely in my original culture? 2. If someone prepares and plates a 10-6 dilution of an E. coli culture, this is a _____ dilution. 1:100 1:10,000 1:1,000,000 1:1,000 3. You...
Exercise Prescription Lab Questions:   1.) Do you think using a fitness score as a screening tool...
Exercise Prescription Lab Questions:   1.) Do you think using a fitness score as a screening tool for physically taxing occupations is fair to all participants? Why or why not? If yes, which occupations why? 2.) In what other settings do you use a step test being useful? why?
Assume that you are a technical engineer of a materials testing lab, and received a report...
Assume that you are a technical engineer of a materials testing lab, and received a report on bi-axial test on a thin stainless steel plate as shown in the figure. The test results indicates that the strains measured in the plate are εy = 488 µε and εx = 654 µε. You recall that the Poisson's ratio is v=εlat/εlong. Assuming εx = εlong and εy = εlat , one would get v=0.75. Given this information, answer the following questions in...