Question

7) Describe the cause of groundwater depletion and use the Ogallala Aquifer as an example.

7) Describe the cause of groundwater depletion and use the Ogallala Aquifer as an example.

Homework Answers

Answer #1

Groundwater is one of our most valuable resources—even though you probably never see it or even realize it is there. There is water somewhere beneath your feet no matter where on Earth you live. Groundwater starts as precipitation, just as surface water does, and once water penetrates the ground, it continues moving, sometimes quickly and sometimes very slowly. Eventually groundwater emerges back to the surface and continues to participate in the global water cycle.

Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
Compound A is released to a groundwater aquifer that has a volume of water of 109...
Compound A is released to a groundwater aquifer that has a volume of water of 109 m3. The pressure of the compound in the vadose soil gas immediately above the groundwater table and at equilibrium is 3 × 10-8 atm. Calculate the total mass of compound A on aquifer material that is 5 × 105 ppm in water There are no other contaminants in the system. - Density of aquifer material = 1.5 g/cm3 - Organic carbon of aquifer material...
An unconfined aquifer is 25 m thick. Groundwater is being pumped out from a 0.10 m...
An unconfined aquifer is 25 m thick. Groundwater is being pumped out from a 0.10 m diameter fully penetrating well. The pumping rate is Qp=0.15 m3 /min. The aquifer is relatively sandy with a hydraulic conductivity of 8.2 m/d. Steady-state drawdown of 1.5 m is observed in a monitoring well 3 m away from the pumping well. Estimate (a) the drawdown 10 m away from the pumping well, (b) the drawdown in the pumping well.
In an aquifer two wells are located 1400 m apart with a difference in head of...
In an aquifer two wells are located 1400 m apart with a difference in head of 22 m. The cross sectional area of the aquifer is 30 m thick and 120 m wide with a hydraulic conductivity of 7 m/day. The average linear velocity between the wells is 0.5 m/day. Find the volume of the groundwater flowing across the cross-sectional area in m3/day and the porosity. (Hint: Use Darcy's Law)
Describe what defines an artesian groundwater bore. Then explain why the sustainable management of artesian bores...
Describe what defines an artesian groundwater bore. Then explain why the sustainable management of artesian bores may need to be different from pumped bores.
Describe (in 100-200 words) the purpose of Depreciation (and Amortization and Depletion) and identify the Generally...
Describe (in 100-200 words) the purpose of Depreciation (and Amortization and Depletion) and identify the Generally Accepted Accounting Principle(s) or Concepts that require this treatment for Long-Term Assets.
4. The aquifer of the example in note 4/4 has an organic fraction, foc, of 0.006,...
4. The aquifer of the example in note 4/4 has an organic fraction, foc, of 0.006, a dry bulk density, ρb, of 2,100 kg/m3, Kow = 240, and a porosity, Φ of 0.35. Estimate the total amount of TCE present by assuming Vbulk = 18750 m3, and Cavg = 129 mg/L.
. Describe an example of when it might be appropriate to use a binomial experiment in...
. Describe an example of when it might be appropriate to use a binomial experiment in the real world.
2. Describe the physiological response to a reduced total body Na+ content (salt depletion). Include in...
2. Describe the physiological response to a reduced total body Na+ content (salt depletion). Include in your answer the roles of hormones, nerves and pressure natriuresis/diuresis. Please give a detailed answer. Add supportive equation if possible.
Explain what is meant by just cause. Give an example of just cause.
Explain what is meant by just cause. Give an example of just cause.
Describe CRC cards and their use. Then use UML diagrams to illustrate an example of how...
Describe CRC cards and their use. Then use UML diagrams to illustrate an example of how you can identify inheritance, aggregation, and dependency relationships between classes.