Question

A treatment plant had a flow of 5.5 mgd and the desired chlorine dosage is 3.5...

A treatment plant had a flow of 5.5 mgd and the desired chlorine dosage is 3.5 mg/L. How many tons per week would be used, if the chlorine were 100% gas?

a. .56
b. 1123.8
c. 160.55
d. 56
Math   Advanced-Math   
0 0
Add a commentTranscribed image text
Next >

Homework Answers

Answer #1

0 0
Know the answer?
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for?
Ask your own homework help question
Similar Questions
The volumetric flow to the ACME wastewater treatment plant is 25 MGD. The influent soluble BOD5...
The volumetric flow to the ACME wastewater treatment plant is 25 MGD. The influent soluble BOD5 is 200 mg/L and the effluent soluble BOD5 is 8 mg/L. The plant is designed to operate with a mean cell (biomass) residence time of 10 days. The yield coefficient is 0.6 mg biomass/mg substrate, and the biomass decay rate is 0.09/day. The reactor is to operate at a biomass concentration of 2500 mg/L. The thickened underflow biomass concentration from the secondary clarifier is...
A new disinfection system is being designed for a treatment plant with a flow of 400...
A new disinfection system is being designed for a treatment plant with a flow of 400 m3/min. The desired chlorine concentration in the treated water is 7 mg/L. (a) It is proposed to inject a concentrated chlorine feed solution into the main flow. If the chlorine concentration in the feed solution is 150 mg/L, what flowrate is required? (b) If the applicable Ct factor is 180 mg-min/L, what volume of chlorine contact chamber is needed? (c) State whether the chlorine...
A 14 mgd wastewater treatment plant has a primary clarifier that treats an influent with 800...
A 14 mgd wastewater treatment plant has a primary clarifier that treats an influent with 800 mg/L of solids and a removal efficiency of 55%. Sludge at the bottom of the tank is pumped at a rate of 0.1 mgd. a. What is the effluent solids concentration from the clarifier (in mg/L)? b. What is the solids concentration in the sludge at the bottom of the tank (in mg/Land %)? c. The primary sludge is further processed in a digester...
Two part question: 1) Design a chlorine contact basin (serpentine) to disinfect 1 MGD flow and...
Two part question: 1) Design a chlorine contact basin (serpentine) to disinfect 1 MGD flow and meet 4- log virus removal with a free chlorine residual of 0.1 mg/L (pH=7, Temp = 25C). Use a length:width ratio of approximately 20:1 and a depth of 4 to 6 feet. 2) Alter the design to achieve 3-log removal of Giardia cysts using free chlorine (still must treat 1 MGD, pH=7, T = 25C). How would the design change if you used chlorine...
Problem #3: Biochemical Oxygen Demand (BOD) and Stream Quality A wastewater treatment plant designed for a...
Problem #3: Biochemical Oxygen Demand (BOD) and Stream Quality A wastewater treatment plant designed for a community of 45,000 people has a flow of 100 gal/person/day and a BOD5 loading of 0.2 lb/person/day. The upstream characteristics of the receiving waters are: stream flow rate = 20 cfs and BOD5 = 2 mg/L The water quality standards require the in-stream BOD5 to be less than 7 mg/L in this stretch of the river. The minimum BOD removal efficiency that the treatment...
A wastewater treatment plant disposes of its effluent in a surface stream. Characteristics of the stream...
A wastewater treatment plant disposes of its effluent in a surface stream. Characteristics of the stream and effluent are given in the table below. What will be the dissolved oxygen concentration in the stream after 2.0 days? (10 Points) What will be the lowest dissolved oxygen concentration as a result of the waste discharge? (10 Points) Parameter Wastewater Stream Flow, m3/s 0.2 5.0 Dissolved Oxygen, mg/L 1.0 8.0 Temperature, o C 15.0 20.2 BOD5 at 20oC, mg/L 100 2.0 k1...
A 1.0 � 106 gallon reactor is used in a sewage-treatment plant. The influent biochemical oxygen...
A 1.0 � 106 gallon reactor is used in a sewage-treatment plant. The influent biochemical oxygen demand (BOD) concentration is 100 mg/L, the effluent BOD concentration is 25 mg/L, and the flow rate through the reactor is 500 gal/min. (a) What is the first-order rate constant for decay of BOD in the reactor? Assume that the reactor can be modeled as a comply mixed flow reactor (CMFR). Report your answer in units of per hour. (b) Assume that the reactor...
1) True / False Dose and dosage express the same value 2) What units would you...
1) True / False Dose and dosage express the same value 2) What units would you use to express concentration? a. mg/mL b. % c. g/L d. all of the above 3) If a doctor asked you to calculate a dose, which of the following choices would be the potential units for your answer? a. mg/kg b. tablets c. % d. mg 4) A drug's weight could include which of the following units? a. mL b. % c. mg/kg d....
Question 1 a) The recommended daily dosage of pseudoephedrine hydrochloride for a child is 0.05 g/kg...
Question 1 a) The recommended daily dosage of pseudoephedrine hydrochloride for a child is 0.05 g/kg in three divided doses. You have a 15% w/v solution of pseudoephedrine hydrochloride. How many mL of this cold remedy should a 16 kg child be given per dose? b) Calculate the molarity (M) of a 10% aqueous solution of MgCl2 (molecular weight: 94. c) You receive a script for Vitamin A solution 3500 units per day. There is a commercially available product containing...
Given the following questions, I would like to know the answers to c, d, and e....
Given the following questions, I would like to know the answers to c, d, and e. located at the bottom (due to 4 answers per post limit). Thanks! Platinum (Pt) is used in part of your car's catalytic converter to reduce carbon monoxide emissions by the following chemical reaction: 2CO(g) + O2(g) Pt 2CO2(g) ---> 1) A matrix contains 7.1mg Pt/g of matrix. What is the %Pt in the matrix by mass? mass of pt = 7.1 mg mass of...
ADVERTISEMENT
Need Online Homework Help?

Get Answers For Free
Most questions answered within 1 hours.

Ask a Question
ADVERTISEMENT